[. . . ] Simply press the mode selector as indicated below - for the Philips device you wish to operate, and press to test. For other brands of equipment, it needs to be set up firstsee Getting Started. [. . . ] philips' patented Handsfree autosearch tests all the codes one after another and finds the right one for you!You will know when the correct code has been found because the equipment will switch off or the VCR will stop playback. 1 Press and hold 1 and 3 at the same time until the green LED lights up. When the right code is found, the equipment switches off (the VCR will stop playing). If you missed the correct code because the search went too far, switch the equipment back on, then press P (down) to send the previous code again. 4 Once you've found the correct code, press The green LED blinks twice. Now, switch the equipment manually on again, then press a few keys on the remote to check that the equipment responds correctly. In the rare instance that it doesn't, try again from step 1 to find a better code. To save time if you ever need to setup again, make a note of the correct code inside the battery case and in the back of this booklet. In case you have forgotten to note the code you can still 'read out' the code from the remote. Here's how: 1 Make sure you've selected the right mode (with ). Then press and release 1 and 6 at the same time; the green LED lights up. ADVANCED TIPS AND TRICKS TO CHANGE SAT MODE TO CONTROL A SECOND TV The SAT mode on this remote is used to control additional equipment. It is factory preset to control a satellite receiver, but you can change it to control a second TV, for example. [. . . ] För att växla mellan funktionerna, tryck en gång för att aktivera, sedan en gång till för att gå till nästa läge. Vartefter som du lägger till nya komponenter till ditt Philipssystem för underhållning i hemmet finns det en universell fjärrkontroll som motsvarar dina nya behov. [. . . ]